Remodeling a 3D printer right into a four-axis digital camera slider


Remodeling a 3D printer right into a four-axis digital camera slider

Arduino WorkforceAugust nineteenth, 2022

When creating movies, making easy, stage actions at a continuing pace is commonly a vital requirement, as sudden adjustments can depart viewers uncomfortable. However reasonably than buying an costly gimbal-stabilized rig or a industrial motorized digital camera platform, Instructables consumer dslrdiy determined to devise their very own four-axis system utilizing a repurposed 3D printer with the objective of with the ability to simply management it via a telephone.

The outdated 3D printer already contained a lot of the components for this construct, resembling a number of stepper motors, a controller board, and loads of miscellaneous {hardware}. The primary axis on the base permits for the first meeting to maneuver side-to-side with only a single stepper motor, whereas the opposite three axes sit on high. These embrace tilting up and down, rotating across the Z-axis, and rolling.

Controlling all of those motors is an Arduino Mega 2560 operating an occasion of RAMPS firmware, which interprets incoming GCODE instructions into bodily actions. And since it lacks a technique to talk by way of Bluetooth®, an exterior ESP32 acts as a distant with a purpose to collect inputs from both its bodily buttons or a related telephone. Mixed, these gadgets can be utilized to set limits and charges for every axis that may, in flip, create wonderful timelapse movies with ease.

To see extra about this undertaking, you possibly can learn dslrdiy’s write-up right here.

You’ll be able to comply with any responses to this entry via the RSS 2.0 feed.
You’ll be able to depart a response, or trackback from your personal website.



Similar Posts

Leave a Reply

Your email address will not be published.